cHapteR 7: paRt ReplaceMent GuiDe
7.12 ecb (electRonic bRaKe) ReplaceMent - continueD
8) once the ECB and drive axle assembly are loose, the drive belt can be removed from around the drive axle assembly pulley allowing the
ECB to drop down outside of its bracket (Figures I & j).
fiGuRe i
fiGuRe J
9) once the ECB is dropped down outside of its bracket, the drive can be removed from around the ECB pulley (Figure K).
10) on the left side, move the mounting bearing from the drive axle assembly towards the middle of the frame. this will allow you to move the
belt around the drive axle assembly and off the unit (Figure l).
11) now that the belt is removed, the ECB can be removed from the frame through the rear. you will need to line up the ECB with the existing
grooves in the frame for removal (Figure M).
fiGuRe K
fiGuRe l
fiGuRe M
12) reverse steps 1-11 to install a new ECB.
13) test the suspension elliptical for function as outlined in section 7.21.
39