Vision Fitness S7100 Suspension elliptical Service Manual page 61

cHapteR 8: SuSpenSion elliptical aSSeMbly GuiDe
8.3 aSSeMbly inStRuctionS - continueD
* when both top tubes are onto the elevation
bracket alignment pin, lift the entire assembly
slightly to line up the bolt holes. Insert the 4 socket
head cap bolts through these holes. secure each
bolt with a nylon nut.
* tighten the left and right top tube / incline arm
bolts.
* tighten the 4 elevation bracket bolts.
* Center the incline frame pivot shaft between the
left and right side, make sure the housings are
pressed tight toward the plastic bushings and then
tighten the 4 bolts, at the lower rear pivot of the
bottom of the incline arm. .
57