Sending Data To A Server (Scan To Ftp); Scan To Ftp; Using Programs - Konica Minolta bizhub C450 Network Scanner Operations

Scanning documents
2.4

Sending data to a server (scan to FTP)

Scan to FTP

The Scan to FTP operation can be used in a network environment with an
FTP server. The scanned data is sent to a specified folder in an FTP server
on the network.
This function is suitable for sending data of a large size such as high-resolu-
tion images.
The methods described below are available for specifying the destination.
The methods can also be combined, for example, by selecting a group des-
tination, then adding other destinations through direct input.
Transmission may not be possible if the destination server has placed limita-
tions on the document name. Because the document name becomes the file
name at the time of transmission, consult your network administrator when
specifying the document name.
Note
If a mail server is available on the network, the e-mail notification function
can be used to send an e-mail message containing notification of the
storage location of the scan data. For details on the e-mail notification
function, refer to "Specifying e-mail settings" on page 2-77.

Using programs

"Program" refers to a set of destination FTP servers and scan settings that
are registered together. The following procedure describes how to send data
by selecting a program that has been registered in advance.
If a proxy server is available on the network, FTP servers on the Internet can
be accessed via a proxy server.
For details on registering programs, refer to "Registering program destina-
tions" on page 3-25.
1
Press the [Scan] key on the control
panel.
The scan mode screen appears.
C450
2
2-21