Setting The Language (Upon First Use); First Use - Use After A Long Period Of Inactivity - Saeco aulika SUP040 Operating Instructions Manual

Machine Installation - Service Provider Manual
is switched to "0".
The Service Provider makes and is responsible for the electrical
connection of the machine.
The machine should be connected to the mains using the plug
installed on the power cord, in accordance with:
• The Laws and Regulations in force at the place and time of
installation;
• The information shown on the technical specifi cations plate
on the side of the machine.
Warning: The electric socket which the appliance
is connected to should be easily accessible by the
user, in order to allow it to be easily disconnected from
the mains when necessary.
It is forbidden to:
• Use extensions of any kind.
• Replace the original plug.
• Use adapters.
8.9

Setting the Language (Upon First Use)

At fi rst start up, the desired language for the display of messages
must be selected and stored. This allows the beverage parameters
to be adjusted to the specifi c taste of the country where the ma-
chine is in use.
LANGUAGE
ITALIANO
ENGLISH
DEUTSCH
FRANÇAIS
1 Select the language by pressing the "
" " button (25).
2 Press the " " button (21) to store the language.
3 The machine starts the system warm-up.
Note: Upon fi rst use, once the warm-up is com-
plete the machine primes the circuit and performs
a rinse cycle of the internal circuits. During this process, a
small amount of water is dispensed. Wait for this cycle to
be completed.
• 28 •
8.10 First Use - Use After a Long Period
of Inactivity
For a perfect Espresso: Rinse the coff ee circuit if using the
machine for the fi rst time or after a long period of inactiv-
ity.
These simple operations will allow you to always brew excellent
coff ee. They have to be performed:
A) At fi rst start-up;
B) When the machine remains inactive for a long time (more
than 2 weeks).
1 (Fig.5, page 3) Place a large container under the dispens-
ing spout.
2 Empty the water tank, wash and rinse it and fi ll it with fresh
water.
3 Select the pre-ground coff ee brewing function by pressing
the " " button (19) once.
The display indicates that the pre-ground function has been se-
lected.
4 Press the "
Note: Do not add pre-ground coff ee to the com-
partment.
Press the "
5
The machine will dispense hot water through the dispensing
spout. Wait until the dispensing procedure is complete and empty
" button (24) or
the water tank.
Repeat the operations from step 1 to step 5 three times, then
6
continue with step 7.
7 (Fig.7, page 3) Place a container under the hot water wand.
8 Press the "
select and start dispensing HOT WATER.
9 When the hot water dispensing procedure is complete,
empty the container.
10 The machine is now ready for use.
" button (21) to select the coff ee.
" button (21) to start the brewing procedure.
" button (22) and the " " button (21) to