Handling And Storage; Handling; Storage; Installation - Saeco aulika SUP040 Operating Instructions Manual

7 HANDLING AND

STORAGE

All the operations described in chapter 7 must
be performed exclusively by the service provider
or a specialised technician, who shall organise
all the operating steps and use only suitable means to en-
sure strict compliance with the safety regulations in force.
7.1

Handling

During handling and transportation, the machine must be kept in
an upright position, according to the instructions printed on the
packaging. Care should be taken during lifting and positioning.
Do not shake the machine.
Make sure that nobody is standing in the area
during load lifting and handling. In diffi cult con-
ditions, assign suitable personnel to monitor all move-
ments.
7.2 Storage
The machine should be stored in accordance with the following
conditions:
- Minimum temperature: above 4°C;
- Maximum temperature: below 40°C;
- Maximum humidity: below 95%.
The machine is packed in cardboard and expanded polystyrene
packaging.
Warning. Due to the total weight of the packaged
product, do not stack more than three machines
on top of each other. The machine should be stored in its
original packaging, in a dry and/or dust-FREE place.
Machine Installation - Service Provider Manual
8

INSTALLATION

All the operations described in chapter 8 must
be performed exclusively by the service provider
or a specialised technician, who shall organise
all the operating steps and use only suitable means to en-
sure strict compliance with the safety regulations in force.
8.1

Safety Regulations

• Read the entire instruction manual carefully.
• The machine should be connected to the mains according to
the safety regulations in force in the country where the ma-
chine is used.
• Connection to the drinking water network (for water-net-
work supplied machines) should be made in compliance with
the safety regulations in force in the country where the ma-
chine is to be used.
• The socket to which the machine is connected should be:
- compatible with the type of plug installed on the ma-
chine;
- suitably sized to comply with the data on the plate at-
tached to the bottom of the appliance;
- connected to an effi cient earthing system.
• The power cord should not:
- come into contact with any type of liquid: danger of elec-
tric shocks and/or fi re;
- be crushed and/or come into contact with sharp surfaces;
- be used to move the machine;
- be used if damaged;
- be handled with damp or wet hands;
- be wound in a coil when the machine is in use;
- be tampered with.
• If the power cord is damaged, it must be replaced by the
manufacturer or an authorised service centre, or in any case
by a person with a similar qualifi cation.
• It is forbidden to:
- Install the machine other than as described in Chapter 8,
or outdoors.
- Install the machine in a location where water jets may be
used.
- Disable the safety features installed by the manufacturer.
- Use the machine close to fl ammable and/or explosive ma-
terials.
- Leave plastic bags, polystyrene, nails, etc., within the
reach of children, as they are potential hazards.
- Allow children to play near the machine.
- Use spare parts other than those recommended by the
manufacturer.
• 25 •