Figure 7-6 Menu 11.5: Remote Node Filter (Ethernet Encapsulation) - ZyXEL Communications ZyWall 10 User Manual

ZyWALL 10~100 Series Internet Security Gateway
Table 7-4 Remote Node Network Layer Options Menu Fields
FIELD
Once you have completed filling in Menu 11.3 Remote Node Network Layer Options, press [ENTER]
at the message "Press ENTER to Confirm..." to save your configuration and return to menu 11, or press
[ESC] at any time to cancel.
7.5 Remote Node Filter
Move the cursor to the field Edit Filter Sets in menu 11.1, and then press [SPACE BAR] to set the value
to Yes. Press [ENTER] to open Menu 11.5 - Remote Node Filter.
Use menu 11.5 to specify the filter set(s) to apply to the incoming and outgoing traffic between this remote
node and the ZyWALL to prevent certain packets from triggering calls. You can specify up to 4 filter sets
separated by commas, for example, 1, 5, 9, 12, in each filter field. Note that spaces are accepted in this
field. For more information on defining the filters, please refer to the Filters chapter. For PPPoE or PPTP
encapsulation, you have the additional option of specifying remote node call filter sets.

Figure 7-6 Menu 11.5: Remote Node Filter (Ethernet Encapsulation)

7-10
DESCRIPTION
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Enter here to CONFIRM or ESC to CANCEL:
EXAMPLE
Remote Node Setup