ZyXEL Communications ZyWall 10 User Manual page 79

Table 7-4 Remote Node Network Layer Options Menu Fields
FIELD
(Rem) IP If you have a Static IP Assignment, enter the subnet mask assigned to
Subnet Mask you.
Gateway IP This field is applicable to Ethernet encapsulation only. Enter the
Addr gateway IP address assigned to you if you are using a static IP
address.
My WAN This field is applicable to PPPoE and PPTP encapsulations only. Some
Addr implementations, especially the UNIX derivatives, require the WAN link
to have a separate IP network number from the LAN and each end
must have a unique address within the WAN network number. If this is
the case, enter the IP address assigned to the WAN port of your
ZyWALL.
Note that this is the address assigned to your local ZyWALL, not the
remote router.
Network Press [SPACE BAR] and then [ENTER] to select either Full Feature,
Address None or SUA Only. See the NAT chapter for a full discussion on this
Translation feature.
Metric Enter a number from 1 to 15 to set this route's priority among the
ZyWALL's routes (see the Metric section in the WAN and Dial Backup
Setup chapter) The smaller the number, the higher priority the route
has.
Private This field is valid only for PPTP/PPPoE encapsulation. This parameter
determines if the ZyWALL will include the route to this remote node in
its RIP broadcasts. If set to Yes, this route is kept private and not
included in RIP broadcast. If No, the route to this remote node will be
propagated to other hosts through RIP broadcasts.
RIP Direction Press [SPACE BAR] and then [ENTER] to select the RIP direction from
Both/ None/In Only/Out Only. See the LAN Setup chapter for more
information on RIP. The default for RIP on the WAN side is None. It is
recommended that you do not change this setting.
Version Press [SPACE BAR] and then [ENTER] to select the RIP version from
RIP-1/RIP-2B/RIP-2M or None.
Multicast IGMP (Internet Group Multicast Protocol) is a session-layer protocol
used to establish membership in a Multicast group. The ZyWALL
supports both IGMP version 1 (IGMP-v1) and version 2 (IGMP-v2).
Press [SPACE BAR] to enable IP Multicasting or select None to disable
it. See the LAN Setup chapter for more information on this feature.
Remote Node Setup
ZyWALL 10~100 Series Internet Security Gateway
DESCRIPTION EXAMPLE
SUA Only
(default)
1
No
None
(default)
N/A
None
(default)
7-9