Table 3-4 Advanced Wan Port Setup: Call Control Parameters - ZyXEL Communications ZyWall 10 User Manual

Table 3-3 Advanced WAN Port Setup: AT Commands Fields
FIELD
Drop Enter the AT Command string to drop a call. "~" represents a one
Answer Enter the AT Command string to answer a call.
Drop DTR When
Hang Up
AT Response String:
CLID (Calling Line
Identification)
Called Id Enter the keyword preceding the dialed number.
Speed Enter the keyword preceding the connection speed.

Table 3-4 Advanced WAN Port Setup: Call Control Parameters

FIELD
Call Control
Dial Timeout (sec)
Retry Count
Retry Interval
(sec)
WAN and Dial Backup Setup
second wait, e.g., "~~~+++~~ath" can be used if your modem has a
slow response time.
Press the [SPACE BAR] to choose either
is selected (the default), the DTR (Data Terminal Ready) signal is
dropped after the "AT Command String: Drop" is sent out.
Enter the keyword that precedes the CLID (Calling Line Identification)
in the AT response string. This lets the ZyWALL capture the CLID in
the AT response string that comes from the WAN device. CLID is
required for CLID authentication.
Enter a number of seconds for the ZyWALL to keep trying to set up
an outgoing call before timing out (stopping). The ZyWALL times
out and stops if it cannot set up an outgoing call within the timeout
value.
Enter a number of times for the ZyWALL to retry a busy or no-
answer phone number before blacklisting the number.
Enter a number of seconds for the ZyWALL to wait before trying
another call after a call has failed. This applies before a phone
number is blacklisted.
ZyWALL 10~100 Series Internet Security Gateway
DESCRIPTION
DESCRIPTION
Yes or No. When Yes
60 seconds
0 to disable
the blacklist
DEFAULT
+++ath
ata
Yes
NMBR =
TO
CONNECT
DEFAULT
control
3-5