Figure 9-3 Menu 15: Nat Setup; Figure 9-4 Menu 15.1: Address Mapping Sets - ZyXEL Communications ZyWall 10 User Manual

ZyWALL 10~100 Series Internet Security Gateway
11.3, the SMT will use Set 1. When you select SUA Only, the SMT will use the pre-configured Set 255
(read only).
The server set is a list of LAN and DMZ servers mapped to external ports. To use this set, a server rule
must be set up inside the NAT address mapping set. Please see the section on port forwarding in the Web
Configurator User's Guide for further information on these menus. To configure NAT, enter 15 from the
main menu to bring up the following screen.
Configure DMZ and LAN IP addresses in NAT menus 15.1 and 15.2. DMZ IP
addresses must be on subnets separate from LAN IP addresses.
9.2.1 Address Mapping Sets
Enter 1 to bring up Menu 15.1 — Address Mapping Sets.
9-4
Menu 15 — NAT Setup
1. Address Mapping Sets
2. Server Set
3. Trigger Port Setup
Enter Menu Selection Number:

Figure 9-3 Menu 15: NAT Setup

Menu 15.1 — Address Mapping Sets
1.
255. SUA (read only)
Enter Menu Selection Number:

Figure 9-4 Menu 15.1: Address Mapping Sets

NAT