ZyXEL Communications ZyWall 10 User Manual page 206

ZyWALL 10~100 Series Internet Security Gateway
FIELD
Peer ID type Press [SPACE BAR] to choose IP, DNS, or E-mail and press [ENTER].
Select IP to identify the remote IPSec router by its IP address.
Select DNS to identify the remote IPSec router by a domain name.
Select E-mail to identify the remote IPSec router by an e-mail address.
Content When you select IP in the Peer ID Type field, type the IP address of the
computer with which you will make the VPN connection or leave the field
blank to have the ZyWALL automatically use the address in the Secure
Gateway field.
When you select DNS in the Peer ID Type field, type a domain name (up
to 31 characters) by which to identify the remote IPSec router.
When you select E-mail in the Peer ID Type field, type an e-mail address
(up to 31 characters) by which to identify the remote IPSec router.
The domain name or e-mail address that you use in the Content field is
used for identification purposes only and does not need to be a real
domain name or e-mail address. The domain name also does not have to
match the remote router's IP address or what you configure in the Secure
Gateway Addr field below.
Secure Type the IP address or the domain name (up to 31 characters) of the
Gateway Addr IPSec router with which you're making the VPN connection.
Set this field to 0.0.0.0 if the remote IPSec router has a dynamic WAN IP
address (the Key Management field must be set to IKE, see later).
Protocol Enter 1 for ICMP, 6 for TCP, 17 for UDP, etc. 0 is the default and signifies
any protocol.
Local Local IP addresses must be static and correspond to the remote IPSec
router's configured remote IP addresses.
Two active SAs cannot have the local and remote IP address(es) both the
same. Two active SAs can have the same local or remote IP address, but
not both. You can configure multiple SAs between the same local and
remote IP addresses, as long as only one is active at any time.
Addr Type Press [SPACE BAR] to choose SINGLE, RANGE, or SUBNET and press
[ENTER]. Select SINGLE with a single IP address. Select RANGE for a
specific range of IP addresses. Select SUBNET to specify IP addresses on
a network by their subnet mask.
19-8
Table 19-2 Menu 27.1.1: IPSec Setup
DESCRIPTION EXAMPLE
Zw50test.com.
tw
0
SINGLE
VPN/IPSec Setup