D-Link DIR-620 User Manual page 80

DIR-620 Multifunction Wireless Router Supporting 3G/2G, CDMA, WiMAX
with Built-in 4-port Switch
User Manual
Parameter
Operator name
Signal level
Vendor
Model
Revision
IMSI
IMEI
Refresh
Connect/
Change&Connect
Disconnect
When the needed network is available, the name of the operator is
displayed in this field.
The No service value means that your USB modem has failed to
connect to the network type specified in the Enable USB modem
field.
For a 3G/2G USB modem, when the 3G 2G, 2G 3G, or 2G value is
selected from the drop-down list, the No service value shows that
neither conventional (2G) nor 3G network of the operator is available.
When the 3G value is selected from the drop-down list, the No service
value shows that the operator's 3G network is not available. In this case,
the Signal level field displays the signal strength of the operator's
conventional (2G) network.
This field is not displayed for a CDMA USB modem.
The signal level at the input of the modem's receiver. The zero signal
level shows that you are out of the coverage area of the selected
operator's network.
The manufacturer of your USB modem.
The alphanumeric code of the model of your USB modem.
The version of the model of your USB modem.
The code stored in the SIM card inserted to your USB modem.
This field is not displayed for a CDMA USB modem.
The code stored in the firmware of the USB modem.
Click the button to refresh the data on the USB modem connected to the
router.
Click the button to connect to the network of the operator. The button is
displayed when the connection is not established.
Click the button to disconnect from the network of the operator. The
button is displayed when the connection to the operator's network is
established or is being established.
Page 80 of 98
Configuring via Web-based Interface
Description