Exploded View Of Clutch Master Cylinder - Mazda 1983 RX7 Service Manual

clearance exceeds .006" (.15 mm), replace defective part. Coat all
components with clean brake fluid before assembly.
Fig. 3:

Exploded View of Clutch Master Cylinder

B2000 & B2200 master cylinder external appearance is slightly
different.
Reassembly
1) Install primary cup with flat side against piston. Ensure
compensating port is open. To complete assembly, reverse disassembly
procedure. After assembly, fill reservoir with clean brake fluid.
2) Bench bleed master cylinder by holding finger over outlet
port and operating piston with screwdriver. Pump piston until air is
ejected at outlet port and fluid pressure is felt. Install master
cylinder and bleed hydraulic system.
CLUTCH SLAVE CYLINDER
Disassembly (Except GLC Wagon)
With slave cylinder removed, detach dust boot and release
rod. Remove piston and cup assembly from cylinder, using compressed
air if required. Remove spring, bleeder screw and valve. See Fig. 4.
CLUTCH
Article Text (p. 5)
1983 Mazda RX7
For www.iluvmyrx7.com
Copyright © 1998 Mitchell Repair Information Company, LLC
Sunday, August 26, 2001 06:33PM