Combination Switch; Gauge Testing Needle Locations - Mazda 1983 RX7 Service Manual

To install, reverse removal procedure.

COMBINATION SWITCH

Removal
Disconnect battery ground. Remove steering wheel. Remove
column covers and snap ring at top of column (if equipped). Unplug
wiring connectors. Loosen combination switch screw. Remove switch.
Installation
To install, reverse removal procedure.
Fig. 1:

Gauge Testing Needle Locations.

Needle should indicate proper reading when test resistor is connected.
END OF ARTICLE
INSTRUMENT PANEL - STANDARD
Article Text (p. 3)
1983 Mazda RX7
For www.iluvmyrx7.com
Copyright © 1998 Mitchell Repair Information Company, LLC
Sunday, August 26, 2001 03:29PM