Service Tools; Warranty Information - Mazda 1983 RX7 Service Manual

H. Torque wheel lug nuts to the specifications in the service
manual.
I. Test drive the vehicle to confirm repair.
J. If the brake judder is still felt, correct the rear rotor(s)
using steps "C" through "I".

SERVICE TOOLS

The Accu-Turn (model 8750) On-Car Brake Lathe is recommended by
Mazda. The brake lathe is available
Program at 1-800-33-6687.

WARRANTY INFORMATION

(Applies To Vehicles Covered Under Normal Warranty.)
Warranty Type:
Symptom Code:
Damage Code:
Part Number Main Cause:
Operation Number:
NOTE: 1. Unnecessary replacement of rotors will result in warranty
claim denial.
2. Brake pad replacement costs will not be warrantable for
brake judder repair.
3. The 1995 SRT Microfiche (for the MX-3, RX-7, 929, MPV,
Miata, etc.) shows labor times for on-car rotor machining
are 0.7 hrs. Max for one side, and 1.2 hrs. Max for both
sides.
4. If an Accu-Turn on-car lathe is used, apply the labor time
from the table above. If an off-car lathe is used, refer to
the labor times from the 1994 SRT. The next issue of the SRT
microfiche will be revised to show the new labor times.
5. Please refer to the attached sheet for all valid off-car
brake and on-car brake machining operation codes for all
models and model years.
END OF ARTICLE
BRAKE JUDDER REPAIR (CANADIAN) CAT. P, NO. 94-06
For www.iluvmyrx7.com
Copyright © 1998 Mitchell Repair Information Company, LLC
Monday, September 03, 2001 03:36PM
O
83
9B
**** 33 25 *
**** 26 25 * (Rear of Vehicle - Rear Wheel
Drive Only)
P0113AMX/0.7 hrs. (Front/One Side)
P0113BMX/1.2 hrs. (Front/Both Sides)
P0214AMX/0.7 hrs. (Rear/One Side)
P0214BMX/1.2 hrs. (Rear/Both Sides)
Article Text (p. 3)
1983 Mazda RX7
through Mazda Canada's Equipment