Mainshaft Rear Bearing; Measuring Clearance Between "C" Washers And Thrust Washer - Mazda 1983 RX7 Service Manual

MANUAL TRANSMISSION SHIM ADJUSTMENTS CAT. J, NO. 001/90
Fig. 6: Retaining Ring Installation (R-Type)
Note: If the "C" washers are not pushed fully forward in the
mainshaft groove the measurement will be incorrect.
4. While pushing the "C" washers forward, measure the clearance
between the "C" washers and thrust waster.
Fig. 7: Measuring Clearance Between "C" Washers & Thrust Washer
(R-Type)
Standard Clearance:

MAINSHAFT REAR BEARING

1. Drive on the mainshaft rear bearing using a suitable pipe, fully
seating it against the front "C" washers.
2. Install the original "C" washers and hold them with the retaining
ring.
Article Text (p. 5)
1983 Mazda RX7
For www.iluvmyrx7.com
Copyright © 1998 Mitchell Repair Information Company, LLC
Saturday, September 08, 2001 09:44AM
Refer to the appropriate service information for
the vehicle being repaired.
(See Fig. 7).
See Fig. 8.