Boottest; Table E-2. Communications Parameters - HP Integrity rx6600 User's & Service Manual

Operation
Use this command to change the speed for a UART in the system. This command works for all UARTs visible
to EFI/POSSE. If the UART is part of processor dependent hardware (PDH) space and is initialized by the
core firmware, this command communicates the settings to core firmware so the UART can be initialized with
the new settings on the next boot.
System default is 9600 baud.
Other communication parameters are listed in Table E-2.
Table E-2 Communications Parameters
Parameter
RECEIVE_FIFO_DEPTH
TIMEOUT
PARITY
DATA_BITS
STOP_BITS
CONTROL_MASK

boottest

Interacts with the speedy boot variable enabling it to be set appropriately.
Syntax
boottest
boottest on
boottest off
boottest [test]
boottest [test] [on|off]
Parameters
[test] Each test can be set or cleared:
booting_valid
early_cpu
late_cpu
platform
chipset
io_hw
mem_init
mem_test
Example E-6 boottest Command
Shell> boottest
BOOTTEST Settings Default Variable
Selftest Setting
------------- -------------------------
booting_valid On (OS speedy boot aware)
early_cpu Run this test
late_cpu Run this test
platform Run this test
Appendix E
Value
1
1000000
No parity
8
1
0
Displays status of all speedy boot bits
Run all tests (for a normal boot time)
Skip all tests (for a faster boot time)
Displays status of specific Speedy Boot bit
Sets or clears a specific Speedy Boot bit
Enable/disable system firmware response to BOOTING
bit. If OS Speedy Boot aware set to on.
Enable/disable early CPU selftests.
Enable/disable late CPU selftests.
Enable/disable system board hardware tests.
Enable/disable CEC tests.
Enable/disable EFI driver Core I/O tests.
Enable/disable memory initialization.
Enable/disable full destructive memory tests.
Utilities
EFI/POSSE Commands
305