Power Supply; Figure 2-10 Power Leds; Table 2-10. Power Supply Led - HP Integrity rx6600 User's & Service Manual

Power Supply

The server can have one or two power supplies, labeled PS0 and PS1. Each power supply has an ac input
receptacle and an LED that shows the power state of the server (Figure 2-7).
The server has three power states: standby power, full power, and off. Plug the power cord into the
appropriate receptacle on the rear of the chassis to achieve the standby power state. To bring the server to full
power plug the power cord into the appropriate receptacle, and either activate the power using the iLO 2 MP
PC command, or push the power button. To bring the server to the off state, unplug the power cords.
Table 2-10 lists the power supply LED states.
Table 2-10 Power Supply LED
Power Supply Condition
No ac power
ac power; standby power on
Full power on; normal operation
Power supply failure
Figure 2-10 shows the power LEDs.
Figure 2-10 Power LEDs
Chapter 2
Power Supply LED
Off
Blinking green
Solid green
Blinking amber
Power LEDs
PS0
PS1
Controls, Ports, and LEDs
Rear Panel
45