Baud; Syntax; Parameters; Operation - HP Integrity BL870c User's & Service Manual

Example 5 help cpuconfig command
Shell> help cpuconfig
CPUCONFIG [cpu] [on|off]
cpu
on|off Specifies to configure or deconfigure a cpu
Notes:
1. Cpu status will not change until next boot
Examples:
* To deconfigure CPU 0
fs0:\> cpuconfig 0 off
CPU will be deconfigured on the next boot
* To display configuration status of cpus
fs0:\> cpuconfig
<CPU configuration data displayed>

baud

Sets the baud rate and communication settings for a universal asynchronous receiver-transmitter
(UART).

Syntax

baud <index> <baudrate>

Parameters

<index> 0 through the total number of UARTS minus one
<baudrate>

Operation

Use this command to change the speed for a UART in the server. This command works for all UARTs
visible to EFI/POSSE. If the UART is part of processor dependent hardware (PDH) space and is
initialized by the core firmware, this command communicates the settings to core firmware so the
UART can be initialized with the new settings on the next boot. System default is 9600 baud.
Other Communication parameters are listed in
Table 30 Communications Parameters
Parameter
RECEIVE_FIFO_DEPTH
TIMEOUT
PARITY
DATA_BITS
STOP_BITS
CONTROL_MASK

boottest

Interacts with the speedy boot variable allowing it to be set appropriately.
Syntax
boottest
boottest on
152 Utilities
Specifies which cpu to configure
baud rate.
Table 30.
Displays status of all speedy boot bits
Run all tests (for a normal boot time)
Value
1
1000000
No parity
8
1
0