Removing A Rear External Hot-Swappable Chassis Fan Unit; Figure 4-5 Fan Unit Release Button (External) - HP Integrity rx6600 User's & Service Manual

Removal and Replacement
Removing and Replacing a Hot-Swappable Chassis Fan Unit

Removing a Rear External Hot-Swappable Chassis Fan Unit

To remove a rear external hot-swappable chassis fan unit, follow these steps:
Step 1. Press down on the fan release button and pull the fan housing unit straight out from the rear of the
chassis until it stops (Figure 4-5).
Step 2. Insert thumb and forefinger into the openings on the top of the fan and squeeze until the fan
releases from the socket (Figure 4-6).
Step 3. Pull the fan straight up and out of the chassis.
CAUTION
Figure 4-5 shows the external fan unit release button.
Figure 4-5 Fan Unit Release Button (External)
64
To prevent server components from overheating, replace the fan within 20 seconds.
Failure to observe this caution results in the server automatically shutting down to
prevent an overtemperature condition.
Fan Release Buttons
Chapter 4