Basic Lldp Port Settings - D-Link DGS-3600 Series User Manual

Basic LLDP Port Settings

The following window is used to set up LLDP on individual port(s) on the Switch. Open LLDP in the L2 Features folder and
click the Basic LLDP Port Settings link.
The following parameters can be set or displayed:
Parameter
Unit
From/To
Notification State
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 7- 53. Basic LLDP Port Settings window
Description
Select the desired stacking unit, if applicable.
Select a port or group of ports using the pull-down menus.
Used to configure each port for sending notification to configured SNMP trap receiver(s).
Enable or disable each port for sending change notification to configured SNMP trap
receiver(s) if an LLDP data change is detected in an advertisement received on the port from
an LLDP neighbor. The definition of change includes new available information, information
timeout, and information update. In addition, the changed type includes any data update
/insert/remove.
134