D-Link DGS-3600 Series User Manual page 126
Xstack dgs-3600 series layer 3 gigabit ethernet managed switch
Hide thumbs
Also See for DGS-3600 Series:
- User manual (433 pages) ,
- Cli manual (431 pages) ,
- Hardware installation manual (66 pages)
Table of Contents
Advertisement
(1-255)
Last Member Query
Interval (1-25 sec)
Host Timeout (1-
16711450 sec)
Route Timeout (1-
16711450 sec)
Leave Timer (1-
16711450 sec)
Querier State
Querier Router
Behavior
State
Fast Leave
Click Apply to implement the new settings. Click the
Settings window.
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
increased packet loss. This entry field allows an entry of 1 to 255. Default = 2.
This field specifies the maximum amount of time between group-specific query messages,
including those sent in response to leave group messages. Default = 1.
This is the maximum amount of time in seconds allowed for a host to continue membership
in a multicast group without the Switch receiving a host membership report. Default = 260.
This is the maximum amount of time in seconds a route is kept in the forwarding table
without receiving a membership report. Default = 260.
This specifies the maximum amount of time in seconds between the Switch receiving a
leave group message from a host, and the Switch issuing a group membership query. If no
response to the membership query is received before the Leave Timer expires, the
(multicast) forwarding entry for that host is deleted. The default setting is 2 seconds.
Choose Enabled to enable transmitting IGMP Query packets or Disabled to disable. The
default is Disabled.
This read-only field describes the behavior of the router for sending query packets. Querier
will denote that the router is sending out IGMP query packets. Non-Querier will denote that
the router is not sending out IGMP query packets. This field will only read Querier when the
Querier State and the State fields have been Enabled.
Select Enabled to implement IGMP Snooping. This field is Disabled by default.
This parameter allows the user to enable the Fast Leave function. Enabled, this function will
allow members of a multicast group to leave the group immediately (without the
implementation of the Last Member Query Timer) when an IGMP Leave Report Packet is
received by the Switch. The default is Disabled.
Show All IGMP Group Entries
110
link to return to the IGMP Snooping
Advertisement
Table of Contents
