Port Configuration - D-Link DGS-3600 Series User Manual

Port Configuration

This section contains information for configuring various attributes and properties for individual physical ports, including port
speed and flow control.
Port Configuration
Click Administration > Port Configuration > Port Configuration to display the following window:
To configure switch ports:
1. Choose the port or sequential range of ports using the From...To... port pull-down menus.
2. Use the remaining pull-down menus to configure the parameters described below:
The following parameters can be configured:
Parameter Description
From.... To Use the pull-down menus to select the port or range of ports to be configured.
State Toggle this field to either enable or disable a given port or group of ports.
Speed/Duplex
Toggle the Speed/Duplex field to either select the speed and duplex/half-duplex state of the port.
Auto denotes auto-negotiation between 10 and 100 Mbps devices, in full- or half-duplex. The
Auto setting allows the port to automatically determine the fastest settings the device the port is
connected to can handle, and then to use those settings. The other options are Auto, 10M/Half,
10M/Full, 100M/Half and 100M/Full, 1000M/Full_M and 1000M/Full_S. There is no automatic
adjustment of port settings with any option other than Auto.
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 6- 7. Port Configuration window
37