Installing The Airflow Guide; Expansion Card Support; Removing The Expansion Card Support - HP Z800 - Workstation - 6 GB RAM Maintenance And Service Manual

Installing the airflow guide

1. Disconnect power from the workstation (see
2. Remove the side access panel (see
3. Insert the airflow guide tabs into the rear chassis slots
clicks into place in the chassis
Figure 5-6
4. Reinstall all removed components and reconnect any cables that have been disconnected.

Expansion card support

To prevent card movement during shipping, an expansion card support is installed. This section
describes how to remove and install the expansion card support.

Removing the expansion card support

1. Disconnect power from the workstation (see
2. Remove the side access panel (see
78 Chapter 5 Replacing components
as shown in the following figure.
2
Installing the airflow guide
Predisassembly procedures on page
Removing the side access panel on page
, and then lower the airflow guide until it
Predisassembly procedures on page
Removing the side access panel on page
74).
76).
74).
76).
ENWW