Usb Print; Connector For Usb Storage Device - Toshiba e-STUDIO 2500c Operator's Manual

8 JOB STATUS

USB print

This function allows you to print files stored in a USB device connected to the connector for USB
storage device of this equipment. In this function only PDF files (with an extension ".pdf") or
JPEG files (with an extension ".jpg" or ".jpeg") can be printed.
It may take a long time to perform USB printing or cancel it compared to normal printing from
a PC. We recommend normal printing when you print a large number of pages.
PDF files requiring a password to open or print it cannot be printed in this function.
The print range cannot be set. The whole page is printed.
PDF file versions 1.3 to 1.6 are supported. However, the unique functions, such as the
Transparency in the versions 1.4 to 1.6 are not supported.
Displaying USB print job list
1
Connect the USB device to the
connector for USB storage
device.
After a few seconds, "FOUND USB
DEVICE" appears in the upper right part
of the screen.
Removing USB device
Check that "USB DEVICE in use Do not
remove USB DEVICE" is not appearing.
Do not disconnect the USB device while
this message is displayed. This could
destroy data in the USB device or cause
a malfunction in this equipment.
2
Press the [JOB STATUS] but-
ton on the control panel.
The print job list is displayed.
290 Confirming Print Job Status