Energy Saving Mode - Toshiba e-STUDIO 2500c Operator's Manual

1 BEFORE USING EQUIPMENT
3
"Processing job will be deleted. Are you sure you want to shut-
down?" appears on the menu. Press the [YES] button.
To cancel the shutdown operation, press the [NO] button.
4
"Shutdown in progress" appears on the menu. After a while, the
equipment is shut down and the power is turned OFF.
The power switch automatically returns to the OFF position.

Energy Saving Mode

This equipment supports two energy saving modes; the Automatic Energy Save mode and the
Sleep Mode.
Automatic Energy Save
The equipment enters the Automatic Energy Save mode automatically after a specified period of
time*1 since its last use. During this mode, "Saving energy – Press START button" appears on
the touch panel.
Sleep Mode
The equipment enters the Sleep Mode automatically after a specified period of time*2 since its
last use. During this mode, the message of the Automatic Energy Save mode disappears and
the [ENERGY SAVER / SHUTDOWN] button lights in green.
These modes are automatically cleared upon the reception of print data, Fax data, Internet Fax
data or E-mails. They are also cleared by pressing the [START] button.
Note 1: This period is set at 15 minutes by factory default.
Note 2: This period is set at 60 minutes for the e-STUDIO2500c/3500c and 90 minutes for the e-
STUDIO3510c by factory default.
Contact your service representative to change the default settings noted above.
52 Preparation 1- Turning Power On/Off