Toshiba e-STUDIO 2500c Operator's Manual page 60

1 BEFORE USING EQUIPMENT
7
Place paper in the drawer(s).
Place paper with its copy side up. (The copy side may be described on the wrapping
paper.)
For the maximum number of sheets that can be set, see
paper".
Fan the paper well before placing it in the drawer.
Be sure that the paper height does not exceed the line indicated inside of the guide.
Do not use creased, folded, wrinkled or damp sheets of paper.
Make sure that a gap of 0.5 mm (1.0 mm or less
in total) is left between the paper and the side
guide for plain paper, and approx. 0.5 mm to 1.0
mm (approx. 1.0 mm to 2.0 mm in total) for thick
paper. If the gap is insufficient, it could cause
paper misfeeding.
58 Preparation 2- Setting Copy Paper
P.54 "Acceptable copy
A