Toshiba e-STUDIO 2500c Operator's Manual page 37

8. Saddle Stitch Finisher (MJ-1030)
This finisher enables saddle stitching, in addition to sort/group finishing and stapling. The
Hole Punch Unit (optional, MJ-6004) can be installed to this finisher. The Bridge Unit
(optional, KN-3500) is required for the installation of this finisher.
9. Hole Punch Unit (MJ-6101)
This unit enables you to punch holes on printouts. It can be used by installing it on the Fin-
isher (MJ-1101).
10. Hole Punch Unit (MJ-6004)
This unit enables you to punch holes on printouts. It can be used by installing it on the Fin-
isher (MJ-1030).
Other options available are as follows. Contact your service technician or Toshiba product dis-
tributors for details.
Work Table (KK-3511)
This is a small table for placing originals while the equipment is operated.
Installed on the right-hand side of the equipment
FAX Unit (GD-1210)
This is a unit for using the equipment as a Fax.
Installed inside of the equipment
2nd Line for Fax Unit (GD-1160)
This unit enables to add a line to the Fax to make it 2nd line.
Installed inside of the equipment
The Fax Unit (GD-1210) is necessary.
Desk (MH-1700)
This is a desk for the equipment.
Data Overwrite Kit (GP-1060)
This is a kit to erase the data stored temporarily when copying, printing, scanning, Fax, internet
Fax or network Fax is performed. It overwrites temporarily stored data with random data.
Installed inside of the equipment
512 MB Expansion Memory (GC-1250)
This is the main memory which is used for programs of the equipment and operations. This
memory enables the B4, A3 and FOLIO (LD, LG, 13" LG, COMP) size originals to be scanned
with the slim PDF format.
Installed inside of the equipment
256 MB Expansion Memory (GC-1260)
This is the page memory and is used for temporarily storing data during scanning or printing.
This memory enables scanning in the full colour, auto colour and image smoothing mode with
600 dpi.
Installed inside of the equipment
Wireless LAN Module (GN-1041)
This module enables the equipment to be used in a wireless LAN environment.
Installed inside of the equipment
The Antenna (GN-3010) is necessary.
The equipment cannot be connected to the wireless and wired LAN at the same time.
Description of Each Component 35