2-7-3. Removal/Installation of the Front
Panel
1. Remove the top panel. (Refer to Section 2-7-1.)
2. Remove the bottom plate.
(Refer to Section 2-7-2.)
3. Remove the harness (AC PSW) from the
connector (CN2) on the switching regulator.
4. Remove the flexible card wire from the connec-
tor (CN500) on the KY-616 board.
5. Remove the harness (KY-MB) from the connec-
tor (CN101) on the KY-614 board.
6. Remove the four screws.
7. Pull the front panel to the front to remove it.
8. Re-attach the parts in reverse order of the
disassembling procedure.
Harness (AC PSW)
BVTT3 x 6
Front panel
CN500
Claws
HVR-1500
CN2
Harness (KY-MB)
Flexible card wire
CN101
BVTT3 x 6
2-7-4. Removal/Installation of the Rear Panel
1. Remove the screw (B3 x 5) and toothed washer.
2. Remove the six screws (BV3 x 6) , and remove the
rear panel.
3. Remove the harness from the connector (CN2) on the
CN-1968A board.
4. Re-attach the parts in reverse order of the disassem-
bling procedure.
Harness
Rear panel
BV3 x 6
CN2
B3 x 5
Toothed washer
BV3 x 6
2-11