Sony HDV HVR-1500 Service Manual page 138

7. Reattaching the RMP (T1) retainer
assembly
(1) Fit the two positioning holes in the RMP (T1)
retainer assembly on the two positioning pins
on the MD chassis.
(2) Tighten the two precision screws to fix the
RMP (T1) retainer assembly while drawing
lightly the T drawer arm assembly in the
arrow direction.
8. Reattaching the MIC assembly
Reattach the MIC assembly.
(Refer to Section 6-18.)
9. Reattaching the L push plate
Reattach the L-push plate with the two precision
screws with the two holes in the L push plate
aligned with the two protrusions on the RLR
assembly.
Tightening Torque : 0.1 N.m {1 kgf.cm}
10. Reconnecting the connector
Reconnect the flexible card wire to the connector
(CN17) on the DR-428BG board located on the
back side of the MD chassis.
m
. Be careful not to insert the flexible card wire
obliquely.
. Do insert the flexible card wire straight and
securely as far as it will go.
. Take care not to fold the flexible card wire.
This shortens the life of the flexible card wire.
11. Checking the performance
Check the S/T reel tables move smoothly by
turning the reel shift motor gear by a skewer.
Adjustment after Replacement
12. T-REEL ONLY adjustment
(Refer to Section 4-3-4.)
13. TENSION adjustment
(Refer to Section 4-3-4.)
14. Tape path adjustment
(Refer to Section 7-2.)
6-22
Positioning hole
T drawer arm assembly
L push plate
Protrusion
Precision screw
(a) P1.4 x 3.5
RMP retainer (T1) assembly
Precision screw
(b) P1.4 x 3.5
Positioning hole
Positioning pin
Precision screws
P1.4 x 3.5
HVR-1500