Replacement
1. Replacing the TG1 arm assembly
(1) Remove the precision screw and remove the
TG1 arm assembly from the MD chassis.
(2) Fit two holes in a new TG1 arm assembly on
the two pins on the MD chassis respectively
and fix the assembly with the precision
screw.
Tightening Torque : 0.1 N.m {1 kgf.cm}
2. Cleaning the tape guide
Wipe the tape guide on the TG1 arm assembly
with a cleaning cloth moistened with cleaning
fluid.
Adjustment after Replacement
3. TENSION adjustment
(Refer to Section 4-3-4.)
4. Checking the tape path adjustment
(Refer to Section 7-4.)
HVR-1500
Tape guide
TG1 arm assembly
Precision screw
P1.4 x 3.5
Tape cleaner
Pins
6-37