Saving The Phrases You Assigned (Rps Set Write) - Roland JX-305 Owner's Manual

Chapter 4. One Touch Phrase Playback (RPS)
Saving the Phrases You
Assigned (RPS Set Write)
When you have assigned phrases to create an RPS set
that you like, here's how to save it as a User RPS Set.
1. Make sure that the pattern is stopped.
2. Press [RPS SET] to access the RPS Set Select
page.
When you modify the contents of an RPS set, an aster-
isk "*" will appear at the left of the number, indicating
that the selected RPS set has been modified (edited).
Be aware that if you turn off the power without saving
the modified RPS set, the previous settings will reap-
pear.
3. Hold down [SHIFT] and press [WRITE].
The indicator will blink.
4
The following display will appear, and a cursor "
will appear at the left of the number.
fig.4-12
SHIFT
If you do not wish to change the bank, number or
name, you may skip steps 4–7.
If you decide not to save the pattern, press [EXIT].
4. Use [INC] [DEC] or the [VALUE] dial to select
the save destination bunk and number.
You can also use the BANK and NUMBER [1]–[8] but-
tons to select an RPS set.
* When saving an RPS set, only the user group can be
selected.
At this time, you can press [UNDO/REDO] to check
the name of the RPS set that is currently in the save
destination number. After you have found an RPS set
that you do not mind overwriting, press
[UNDO/REDO] once again to return to the previous
display.
5. Press PAGE [>].
The cursor will move to the beginning of the second
line of the display.
fig.4-13
52
UTILITY
WRITE
6. Assign a name to the RPS set.
Use [INC] [DEC] or the [VALUE] dial to specify the
characters.
The following characters can be selected.
space, A–Z, a–z, 0–9, ! " # $ % & ' ( ) * + , - ./: ; < = > ?
@ [ ¥ ] ^ _ ` {|}
7. Repeat steps 5–6 to input the name.
By pressing PAGE [<] you can move the cursor back
counterclockwise.
8. Press [ENTER].
The execute display will appear.
If you wish to cancel the operation, press [EXIT].
fig.4-14
9. Press [ENTER] once again.
"
fig.0-5
The RPS Set Write operation will be executed, and the
normal display will reappear.
The RPS set has now been saved.