Saving Arpeggio Settings (Arpeggio Write); Playing A Rhythm Set - Roland JX-305 Owner's Manual

Chapter 2. Playing the Keyboard
Octave Range
This is the setting page for "Changing the Pitch Range
of the Arpeggio (Octave Range)" (p. 26).
Range: -3–+3
Velocity
Specify the loudness of the notes that you play.
Range: REAL, 1–127
If you want the velocity value to change according to
how strongly you played each note, set this to REAL.
If you want to produce a constant velocity value
regardless of how strongly each note was played,
2
specify the desired value.
Destination
This is the setting page for "Selecting the Part in Dual
Mode Which Will Play the Arpeggio (Arpeggio
Destination)" (p. 26).
Saving Arpeggio Settings
(Arpeggio Write)
When you have created a playback pattern that you
like, save the settings as a User Style. The JX-305 has
ten user styles, USER STYLE 1–10, and user styles that
you save can be recalled at any time.
* Velocity and Destination Part cannot be saved.
1. Create an arpeggio playback pattern.
2. Make sure that the ARPEGGIO setting page
is shown in the display.
If it is not displayed, press [EDIT] and then press
BANK [4] to access the setting page.
3. Hold down [SHIFT] and press [WRITE].
The indicator will blink, and the following display will
appear.
fig.2-50
SHIFT
4. Use [INC] [DEC] or the [VALUE] dial to speci-
fy the writing destination user style.
Range: USER STYLE 1–10
5. Press [ENTER].
The execute page will appear in the display.
fig.2-51
28
UTILITY
WRITE
6. Press [ENTER] once again.
The Arpeggio Write operation will be executed, and
the normal display will reappear.
To cancel the operation without executing, press
[EXIT].

Playing a Rhythm Set

The JX-305 contains various rhythm sets, each of
which have a different percussion instrument sound
or sound effect assigned to each key.
These rhythm sets can be selected by specifying the
group, bank and number, and are played from the
keyboard.
1. Use [PART SELECT] and PART [R] to select
the rhythm part.
fig.2-52
GROUP
PRESET
PART
PREV NEXT SELECT
USER
CARD
QTZ SELECT
1 1 2 2 3 3 4
BANK
2. In the DISPLAY section, press [PATCH].
The indicator lights, and the display will show the
group, bank, number and name of the currently select-
ed rhythm set.
fig.2-53E
PATCH
3. In the GROUP section, press [PRESET/USER/
CARD] to select the group.
Rhythm set groups are organized as follows:
PRESET → P: A, B (Preset group)
USER → U: (User group)
CARD → C: (Card group)
fig.2-3
GROUP
PRESET
USER
CARD
* The Card group can be selected only when an optional
memory card is inserted.
PART EDIT/UTILITY
PART MUTE
EDIT
MUTE CTRL UTILITY
FX ON/OFF WRITE
4 5 5 6 6 7 7 8 R
PART
Bank
Group Number
Name