Roland JX-305 Owner's Manual page 139

For example, if you wish to copy from measure 4 to
the end of measure 6, make settings as follows.
fig.9-4 (#MC fig.11-3)
8. Press [ENTER].
The display will indicate the group, bank and number
of the copy destination pattern.
9. Select the copy destination pattern.
Range: TMP, P:A11–P:L88, U:A11–U:D18, C:A11
–C:D18
* You can also change the group by pressing
[PRESET/USER/CARD], [<PREV] [NEXT>] in the
GROUP section.
fig.9-5 (#MC fig.11-4)
10. Select the copy destination part.
* If more than one part was selected as the copy source, the
data will automatically be copied to the same parts as the
copy source. If you are unable to select the copy destina-
tion part, make sure that you have not selected two or
more copy source parts.
* If [MUTE CTRL] was selected as the copy source part,
only [MUTE CTRL] can be selected as the copy destina-
tion part.
11. Press [ENTER].
The display will indicate the copy start measure of the
copy destination part.
12. Specify the copy start measure of the
copy destination part.
Range: 1–31, END
* If the setting is "END," the data will be copied onto the
end of the copy destination part.
* It is not possible to specify a measure number that would
cause the length of the pattern to exceed 32 measures.
fig.9-6 (#MC fig.11-5)
13. Press [ENTER].
The display will indicate the type of musical data to be
copied.
14. Select the type of musical data that you
wish to copy.
fig.9-7 (#MC fig.11-6)
Chapter 9. Editing Patterns
Range:
ALL: All musical data
NOTE: Note
Program change
PC:
CC: Control change
BEND: Pitch bend
P-AFT: Polyphonic aftertouch
C-AFT: Channel aftertouch
System exclusive
SYS-EX:
TEMPO: Tempo
MUTE: Mute
15. Press [ENTER].
The display will show the Copy Mode setting.
16. Select the copy mode.
fig.9-8 (#MC fig.11-7)
Range: REPLACE, MIX
REPLACE: Musical data in the copy destination will
be erased (i.e., overwritten) when the
copy takes place.
Musical data in the copy destination will
MIX:
be combined with the newly copied data.
17. Press [ENTER].
The display will let you specify the number of times
that the data will be copied.
18. Specify the number of times that the data
will be copied.
fig.9-9
Range: 1–32
* It is not possible to specify a number of measures that
would cause the length of the pattern to exceed 32 mea-
sures when the Copy was executed.
19. Press [ENTER].
The confirmation page will appear.
fig.9-10 (#MC fig.11-8)
20. Press [ENTER] once again.
The copy operation will be carried out, and the normal
display will reappear.
9
139