Adding Reverberation To The Sound (Reverb); Adjusting The Overall Reverb Volume (Reverb Level); Adjusting The Reverb Volume For Each Part; (Part Reverb Level) - Roland JX-305 Owner's Manual

Chapter 7. Applying Effects to the Sound (Effects)
Adding Reverberation to the
Sound (Reverb)
Reverb is an effect which adds reverberation and
ambiance to the sound, creating an impression of spa-
tial depth. It simulates the sound of music played in a
concert hall. In the REVERB parameters you can make
settings which control the reverb.
Adjusting the Overall Reverb
Volume (Reverb Level)
You can adjust the overall volume of reverb for the
eight parts (parts 1–7 and rhythm part).
1. Press [ENVELOPE/LFO1/EFFECTS] several
times to make the EFFECTS indicator light.
2. Rotate the [REVERB LEVEL] knob to adjust
the Reverb Level.
fig.7-3 (#MC fig.4-6)
ENVELOPE ATTACK
LFO 1 RATE
7
EFFECTS REVERB LEVEL
Range: 0–127
Rotating the knob clockwise will increase the reverb
volume. Rotating the knob counterclockwise will
decrease the reverb volume.
Adjusting the Reverb Volume for
Each Part (Part Reverb Level)
You can adjust the reverb volume for each part.
1. Hold down [SHIFT] and press [MIXER].
The indicator will blink, and the Part Mixer page will
appear in the display.
2. Press PAGE [<] [>] several times to select
the "Revrb" page.
The display will graphically indicate the Part Reverb
Level of each part.
fig.7-4
SHIFT
Part
102
TEMPO &
MEASURE
MIXER
Current Part
3. Use the eight knobs of the REALTIME MODI-
FY section and the QUANTIZE section to set
the Part Reverb Level for each part.
Range: 0–127
fig.3-17
PART
1 2 3 4 5
REALTIME MODIFY
ENVELOPE ATTACK DECAY SUSTAIN RELEASE DEPTH
LFO 1 RATE FADE TIME PITCH DEPTH FILTER DEPTH AMP DEPTH
EFFECTS REVERB LEVEL DELAY LEVEL MULTI CTRL1 MULTI CTRL 2 MULTI CTRL 3
When you enter the Part Mixer page, all indicators of
[ENVELOPE/LFO1/EFFECTS], [FILTER/AMP/
PITCH] and [GRID/SHUFFLE/GROOVE] will blink,
and you can use the eight knobs of the REALTIME
MODIFY section and the QUANTIZE section to adjust
the settings of each part. At this time, the QUANTIZE
settings or REALTIME MODIFY cannot be modified
by the knobs.
4. Press [EXIT] to exit the Part Mixer page.
If you wish to apply reverb to parts that are not using
multi-effects, be aware that if either the Part Reverb
Level of that part or the Reverb Level of all parts is set
to "0," no reverb will be applied to that part. Also, if
you set the Part Multi Effects Switch setting of the
rhythm part to "RHY," you will be able to adjust the
reverb volume for each rhythm tone.
"Specifying the Part(s) to Which Multi-Effects
Will Be Applied (Part Multi-Effects Switch)" (p.
124)
If you wish to adjust the reverb volume for
each rhythm tone...
"R.TONE Rev Level (Rhythm Tone Reverb
Level)" (p. 97)
fig.7-6TEXT
For each rhythm tone
Part 1–7
For each part
Entire rhythm part
All parts
REVERB LEVEL
Reverb sound
Reverb sound
6 7 R
QUANTIZE
FILTER CUTOFF RESONANCE GRID TIMING
VELOCITY
AMP LEVEL PANPOT SHUFFLE
PITCH PORTA TIME FINE TUNE GROOVE