Roland JX-305 Owner's Manual page 117

Space-D (Add Transparent Depth)
This is a type of chorus, but unlike a conventional cho-
rus, it does not create a sense of modulation. It pro-
duces a chorus effect with an impression of trans-
parency.
fig.7-38 (#MC fig.4-48)
Pre Delay (Pre Delay Time)
Specifies the time from the original sound until the
chorus sound is heard.
Range: 0.0–100
Rate
[MULTI CTRL 2]
Specifies the rate of modulation.
Range: 0.1–10.0
2MES 3MES 4MES 8MES 16MES
If a note value or measure is selected as the value of
this parameter, the Rate will synchronize with the
tempo of the pattern at intervals of the specified note
value or measure.
Depth
[MULTI CTRL 1]
Specifies the depth of modulation.
Range: 0–127
Phase
Adjusts the spread of the sound.
Range: 0–180
As this value is increased, the sound will have a
broader left/right spread.
SPACE-D
MULTI CTRL1
Depth
MULTI CTRL 2
Rate
MULTI CTRL3
Output Level
Chapter 7. Applying Effects to the Sound (Effects)
Low Gain
Adjusts the boost or cut of the low frequency range.
Range: -15–+15
High Gain
Adjusts the boost or cut of the high frequency range.
Range: -15–+15
Balance (Effect Balance)
Adjusts the volume balance between the original
sound and the chorus sound.
Range: D100:0E–D0:100E
With a setting of "D100:0E" the chorus sound will not
be heard.
Output Level
[MULTI CTRL 3]
Specifies the output volume from the Space-D effect.
Range: 0–127
Tetra Chorus (Layer Chorus
Sounds to Add Spaciousness)
This effect layers four chorus sounds to produce even
more depth and spaciousness than a conventional cho-
rus.
fig.7-40 (#MC fig.4-50)
Pre Delay (Pre Delay Time)
Specifies the time from the original sound until the
chorus sound is heard.
Range: 0.0–100
TETRA-CHRS
MULTI CTRL1
Depth
MULTI CTRL 2
Rate
MULTI CTRL3
Output Level
117
7