Roland JX-305 Owner's Manual page 35

EDIT
3
FX ON/OFF
PART
5. Press [EXIT] to leave the setting page.
Selecting the patch that will be
assigned to a part
The patch that is assigned to each part is memorized
as part of the pattern settings.
fig.3-25
Adjusting the volume of each part
(Part Level)
fig.3-26
Range: 0–127
With a setting of "127," the volume setting of the patch
itself will be fully active.
Adjusting the pan of each part (Part
Pan)
You can adjust the stereo location in the stereo output
from the OUTPUT jacks.
fig.3-27
3
PAGE
LOWER UPPER
Chapter 3. Playing Patterns
Range: L64–63R
When this setting is at "0," the setting of the patch
itself will be unaffected.
Adjusting the pitch of each part (Part
Key Shift)
You can adjust the pitch of the sound of each part.
fig.3-28
Range: -48–+48 semitones
When the value is "0," the original pitch of the patch
itself will be used without change.
Adjusting the reverb volume for each
part (Part Reverb Level)
The volume of reverberation can be specified for each part.
fig.3-29
Range: 0–127
"Adding Reverberation to the Sound
(Reverb)" (p. 102)
Adjusting the delay volume for each
part (Part Delay Level)
The volume of the delay sound can be specified for
each part.
fig.3-30
Range: 0–127
"Adding an Echo to the Sound (Delay)" (p.
103)
Applying multi-effects to each part
(Part Multi-Effects Switch)
Multi-effects can be switched on/off for each part.
fig.3-31
Range:
OFF : Multi-effects will not be applied.
RHY : The sound will be output according to the
Rhythm Tone Multi-Effects Switch, Rhythm
Tone Reverb Level, and Rhythm Tone Delay
3
35