Operating The Inverter; Test Run - YASKAWA VS-606V7 Series Instruction Manual

5. OPERATING THE INVERTER

Initial setting of control mode selection (n002) is set at V/f control mode.

Test Run

The inverter operates by setting the frequency (speed).
There are four types of operation modes for the VS-606V7 :
1 Run command from the digital operator (potentiometer/digital setting).
2 Run command from the control circuit terminal.
3 Run command from communications (MEMOBUS communications).
4 Run command from communication card (optional)
Prior to shipping, the drive is set up to receive run command and frequency
reference from the operator. Below are instructions for running the VS-
606V7 using the digital operator JVOP-147 (without potentiometer). For
instructions on operation, refer to page 40.
Operation reference or frequency reference constants can be selected
separately as shown below.
Name
n003 = 0 --- Enables operator RUN, STOP/RESET
Run
= 1 --- Enables control circuit terminal run/stop
Command
= 2 --- Enables communications (MEMOBUS communications)
Selection
= 3 --- Enables communication card (optional)
n004 = 0 --- Enables operator potentiometer
= 1 --- Enables frequency reference 1 (constant n024)
= 2 --- Enables voltage reference (0 to 10V) of control circuit
Frequency
= 3 --- Enables current reference (4 to 20mA) of control circuit
Reference
Selection
= 4 --- Enables current reference (0 to 20mA) of control circuit
= 5 --- Enables pulse train reference of control circuit terminal
= 6 --- Enables communications (MEMOBUS communications)
= 7 --- Enables voltage reference (0 to 10V) of operator circuit
= 8 --- Enables current reference (4 to 20mA) of operator circuit
= 9 --- Enables communication card (optional)
Constant
terminal
terminal
terminal
terminal
terminal
31