Appendix B: Setting Up Remote Viewing; What Do I Need - Digimerge DHU600 Series Instruction Manual

Appendix B: Setting up Remote Viewing

APPENDIX B: SETTING UP REMOTE VIEWING
Setting up remote viewing requires several steps. Networking skills are required to correctly
configure the remote viewing functions.

What Do I Need?

• DVR System
• A router (not provided with the system) and High Speed Cable or DSL Internet Connectivity
(for remote viewing outside your network)
INTERNET
Figure 39.0 Network Setup
Network Setup / Remote Access Overview
To setup remote viewing:
1. With the system powered off, connect the system to the router using an Ethernet cable.
NOTE: You must connect the system to the router prior to turning on the system. This allows the system
and router to communicate over the network.
2. Power on the system.
3. Press and hold the Enter button on the front panel to find your system's IP address.
4. Enable Port Forwarding on your router.
5. Setup an account at
94
DVR
ROUTER
(Not Included)
http://ddns.digimerge.net
PC
(Not Included)