Appendix H: Replacing The Hard Drive - Digimerge DHU600 Series Instruction Manual

APPENDIX H: REPLACING THE HARD DRIVE

The system comes with a pre-installed 3.5" SATA hard drive. Make sure that the system is
and the power cable has been disconnected before changing the hard drive. You can add a
maximum of two hard drives.
Removing the Hard Drive
To remove the hard drive:
1. Remove the two short black screws on the side panels of the housing and the three short
black screws on the rear panel. Keep these sets of screws separate.
Figure 41.0 Remove the screws on the side panels and the rear panel. Gently
slide cover off.
2. Carefully slide the cover away from the front panel and lift off from the housing.
Figure 41.1 Gently remove cover. Be careful of sharp edges on the cover.
3. Disconnect the SATA power and data cables from the hard drive(s). Pinch the metal
connectors to unplug the SATA power and data cables.
Figure 41.2 Unplug the SATA data and power cable from the hard drive.
Appendix H: Replacing the Hard Drive
OFF
105