Color Setup; Ptz Setup - Digimerge DHU600 Series Instruction Manual

COLOR SETUP

Use the Color Setup menu to adjust
Brightness, Contrast, Tint, and Color for each
camera.
Figure 17.1 Color Setup menu
To configure color settings:
1. Select COLOR SETUP and press ENTER.
2. Select a channel and press ENTER. The
channel opens in full-screen with the color
options in a bar at the bottom of the
screen.
Figure 17.2 Adjusting color options
3. Select BRIGHTNESS, CONTRAST, TINT, or
COLOR and press ENTER.
4. Increase/decrease level from 0~100 and
press ENTER.
5. Repeat steps 3~4 for remaining channels.
6. Press RETURN to the Color Setup menu.
7. Select APPLY and press ENTER to save
your settings or select CANCEL to restore
defaults.
8. Select CLOSE and press ENTER to exit.

PTZ SETUP

Use the PTZ Setup menu to configure any
connected PTZ cameras (not included).
Make sure your PTZ camera is
NOTE:
properly connected to the system prior to
configuring PTZ options. Please refer to
your PTZ camera's instruction manual to
determine the correct settings for your PTZ
camera.
Figure 17.3 PTZ Setup menu
To configure PTZ settings:
1. Select PTZ SETUP and press ENTER.
2. Under ADDRESS, select a channel and
press ENTER; select 1~255.
3. Under PROTOCOL, select Pel coD, Pel coP
MESA-DOME, D-MAX, FastraxII 2, Ganz PT
V3 2, Scc641, Scc643a, Spd 3300, Multix,
MRX1000, WV-cs850, WV-csr604,
PTC-400c, PTC-200, TAKEX, or
LPT-A100L.
4. Under BAUD RATE, select 9600 (default),
4800, 2400, 115200, 57600, 38400, or
19200.
5. Select DETAIL and press ENTER. The PTZ
Property window opens.
Figure 17.4 PTZ Setup menu
Using the System Menu
31