Appendix D: Connecting Ptz Cameras - Digimerge DHU600 Series Instruction Manual

APPENDIX D: CONNECTING PTZ CAMERAS

You can connect RS-485 PTZ cameras (not included) to the PTZ Control Block on the rear panel of
the system.
VIDEO (BNC)
PTZ CAMERA
(not included)
Figure 40.0 Connecting a PTZ camera (not included)
To install a PTZ Camera:
1. Connect the Transmit Cable to the RS-485 D+ (TX+) port of the PTZ block on the rear panel.
2. Connect the Receive Cable to the RS-485 D- (TX-)port of the PTZ block on the rear panel.
3. Connect the video cable to a BNC port (usually channel 1).
4. Open the SYSTEM SETUP menu and select
5. Select PTZ SETUP and configure the ADDRESS, PROTOCOL, and BAUD RATE of your PTZ
camera.
NOTE: The PTZ camera settings depend on the type of PTZ camera. Please refer to the specific camera
manual for your brand and model of PTZ camera.
6. Select APPLY and press ENTER to save your settings.
NOTE: For details on controlling your PTZ camera, see "PTZ" on page 15.
Appendix D: Connecting PTZ Cameras
DVR
D+ (TX+)/ D- (TX-)
.
CAMERA
101