Selecting A Sequence; Modifying An Existing Sequence; Deleting A Sequence - Digimerge DHU600 Series Instruction Manual

To configure the new sequence:
1. Under VIEW TYPE, select a screen
configuration (single channel, quad,
6-split, 8-split, 9-split, 16-split) and press
ENTER.
2. Select CONFIGURE and press ENTER.
3. Select a square on the grid and press
ENTER. Press the
channel and press ENTER to assign the
channel to the selected square on the grid.
4. Select CONFIRM and press ENTER. The
customized configuration appears on the
previously blank Sequence window.
5. Select ADD and press ENTER. Repeat
steps 6~11 for additional screen
configurations for your sequence.
To edit an existing configuration,
NOTE:
select the grid icon on the Add Sequence
window and press ENTER.
Figure 18.6 Double-click a grid icon to edit that configuration
6. Select CLOSE and press ENTER to exit.
7. Select APPLY and press ENTER to save
your settings or select CANCEL to restore
defaults.
8. From live viewing, press the SEQ button to
start the new sequence.

Selecting A Sequence

You can create up to 16 sequences but only one
can be active. The sequence with a checkmark
under "Activation" is the active sequence on
the system.
To change sequences:
1. Under LIST, select a sequence and press
ENTER. The EDIT window opens.
buttons to select a
Figure 18.7 Edit an existing sequence
2. Under ACTIVATION, select ON and press
ENTER.
3. Select SAVE. and press ENTER. The EDIT
window closes.
4. Select APPLY and press ENTER to save
your settings.

Modifying an Existing Sequence

To modify or edit an existing sequence:
1. Under LIST, select a sequence and press
ENTER. The EDIT window opens.
2. Select MODIFY and press ENTER. The Add
Sequence window opens.
3. Select a grid icon and press ENTER. From
the pop-up window, select MODIFY and
press ENTER to edit the configuration in
the Sequence Setup window.
4. Modify the the sequence using VIEW TYPE
and CONFIGURE options.
5. Select CONFIRM and press ENTER to save
your changes.
6. Select CLOSE and press ENTER to exit.
7. Select APPLY and press ENTER to save
your settings or select CANCEL to restore
defaults.

Deleting a Sequence

To delete a sequence:
1. Under LIST, select a sequence and press
ENTER. The EDIT window opens.
2. Select DELETE and press ENTER. The
EDIT window closes.
3. Select APPLY and press ENTER to save
your settings or select CANCEL to restore
defaults.
Using the System Menu
35