Using The System; Powering On The System; Using The Virtual Keyboard - Digimerge DHU600 Series Instruction Manual

Using the System

USING THE SYSTEM
With the system properly connected, you can power on and begin using the system.

Powering On The System

To power on the system:
1. Press the POWER button on the remote control or front panel. After an initial loading
sequence, the system displays a live split-screen mode. By default, the system begins
recording continuously from any connected cameras.
2. Using the Virtual Keyboard, enter your ADMIN password (by default, 1234) and select ENTER
to log onto the system.
The default system administrator (ADMIN) password is 1234. For complete information
NOTE:
on changing your password and managing users on the system, see "User" on page 41.
To power off the system:
1. Press the PWR button on the remote control to open the Status Bar; press the PWR button
again to open the Log Off/Power Off window.
2. Select POWER OFF and press ENTER on the remote control or front panel.
3. Using the Virtual Keyboard, enter your ADMIN password (by default, 1234) and select ENTER
to log off the system.
Figure 4.0 Log on to the system after start-up

Using the Virtual Keyboard

Use the Virtual Keyboard to enter passwords and camera
titles on the system.
To use the Virtual Keyboard:
1. Select any desired letter, number, or character.
2. Press ENTER on the remote control or front panel.
If desired, select "A" and press ENTER to shift
NOTE:
between upper and lowercase letters.
8
Virtual
Keyboard
Status Bar
Figure 4.1 Virtual Keyboard