Display; Osd; Monitor - Digimerge DHU600 Series Instruction Manual

DISPLAY

Configure the on-screen display
(OSD), monitor settings, Auto
Sequence, and Spot Out.

OSD

Use the OSD menu to customize the
appearance of the on-screen display, as well
as change the system language.
Figure 18.0 OSD menu
To configure OSD settings:
1. Select OSD and press ENTER.
2. Customize the following:
• STATUS BAR TIMEOUT: Set the length of
time for the Status Bar to remain on-screen
(5 sec, 10 sec, 15 sec, 20 sec, 30 sec, 1 min,
or ALWAYS)
• CAMERA TITLE: Select ON/OFF to show or
hide the camera title
• RECORDING MODE ICON: Select ON/OFF
to show or hide the recording mode icons
• BORDER: Select ON/OFF to show or hide
channel borders
• BORDER COLOR: Change the color of the
channel borders; select GRAY (default),
WHITE, RED, GREEN, BLUE, or YELLOW
• MOTION SENSOR DISPLAY: Select ON/OFF
to show or hide the motion sensor display
Motion Sensor Display refers to the
NOTE:
colored pixels that appear on-screen when
motion is detected by one of the cameras.
• MOTION COLOR: Change the color of the
motion sensor display; select BLUE
(default), YELLOW, RED, or GREEN
• LANGUAGE: Change the system language;
select ENGLISH (default), ITALIAN,
SPANISH, THAILAND, JAPANESE,
CHINESE(S), or CHINESE(T)
3. Select APPLY and press ENTER to save
your settings or select CANCEL to restore
defaults.
4. Select CLOSE and press ENTER to exit.

MONITOR

Use the Monitor menu to configure dwell times
and pop-up settings.
Figure 18.1 Monitor menu
To configure monitor settings:
1. Select MONITOR and press ENTER.
2. Customize the following:
• SEQUENCE DWELL: Set the length of time
(in seconds) for each channel to appear
on-screen during Auto Sequence mode;
select from 1 sec, 2 sec, 3 sec, 5 sec
(default), 10 sec, 15 sec, 20 sec, 30 sec, 40
sec, or 60 sec
• SPOT DWELL: Set the length of time (in
seconds) for each channel to appear
on-screen for the Spot Monitor (Spot Out);
select from 1 sec, 2 sec, 3 sec, 5 sec
(default), 10 sec, 15 sec, 20 sec, 30 sec, 40
sec, or 60 sec
• DE-INTERLACE MODE: Select ON/OFF to
enable or disable de-interlace mode
When recording any channels in D1
NOTE:
resolution (704 x 576), this should be set to
ON to prevent judder during playback.
• ALARM POP-UP MODE: Select ON/OFF to
enable/disable the associated alarm
Using the System Menu
33