Appendix B: Setting Up Remote Viewing; What Do I Need - Digimerge DH200+R Series Instruction Manual

Appendix B: Setting up Remote Viewing

APPENDIX B: SETTING UP REMOTE VIEWING
Setting up the Remote Viewing Feature requires several steps. Networking skills are required to
correctly configure the remote viewing functions.

What Do I Need?

• DVR System.
• A PC with CMS-DH software installed.
• A router (not provided with the system) and High Speed Cable or DSL Internet Connectivity
(for remote viewing outside your network).
INTERNET
Network Setup / Remote Access Overview
To setup remote viewing:
1. With the system powered off, connect the system to the router using an Ethernet cable.
2. Power the system on. You must connect the system to the router prior to turning on the
system. This allows the system and router to communicate over the network.
3. Press the INFO button on the remote control to find your system's IP address.
4. Enable Port Forwarding on your router. Refer to the included Router Guide and Basics of
Remote Video Access Guide for further assistance with your specific network setup and
hardware.
5. Setup an account at
130
DVR*
ROUTER
(Not Included)
http://ddns.digimerge.net
PC
(Not Included)