I/O Module Installation and Wiring - I/O Module Installation Procedures
Step
4
NOTE: In the diagram below, the white cut-outs represent the cut-outs on the modules that
cont'd
accommodate tabs on the Terminal Block. That is, all key-tabs that line up with the white cut-
outs on the diagram should be retained, and all other tabs should be removed.
The orientation of the diagrams below corresponds to the picture of the terminal block, shown in
the previous picture.
120/240
VAC,
125VDC
IN
Same as
120/240
Vac IN
76
Procedure
Diagrams for I/O Module Key-Tabs
HC900 Process Controller Installation and User Guide
Comments
Reference
Revision 19
06/14