Honeywell HC900 Installation And User Manual page 221

Appendix - Installation of Remote Termination Panels (RTPs) - Analog Input
8 Point Analog Input
Step
3
Set DIP switch positions SW1 through SW8.
Set each input's DIP switch positions according to the input type. For Input n use Switch n. For example, for
Input 1 use Switch 1, for Input 2 use Switch 2, etc. If an input is not used, set its DIP switch positions to OFF.
Volt, millivolt:
Milliamp:
Externally Powered
SW9 is the red power switch for 24 volt supply. Module RIUP is not affected by using the RTP.
See page 214 for RTP internal schematic.
Revision 19
06/14
Ohms:
RTD:
HC900 Process Controller Installation and User Guide
Action
Fuses: 80mA Time lag
Wickmann part
#3740080041
UL/CSA approved
Transmitter
Transmitter:
:
Loop Powered
209