Appendix - Installation of Remote Termination Panels (RTPs) - Analog Input/Digital Input/Digital Output/Analog
Output
16 Point DC Digital Output
Step
2
Mount RTP to DIN rail.
•
Latch to rail. See page 244.
•
Connect cable to RTP
3
Set/verify jumper positions as shown.
Module Removal / Insertion Under Power (RIUP) is supported by turning off Switch SW1 to allow removal of
the module from the rack without causing an arc. See page 73.
ATTENTION: SW1 only disconnects the positive terminal, not both sides of the DC power.
See page 230 for RTP internal schematic.
226
HC900 Process Controller Installation and User Guide
Action
Jumper open
Jumper closed
Revision 19
06/14