Avidyne IFD540 Installation Manual page 173

IFD540
GPS 429 IN A
GPS 429 IN B
RS-232 OUT
TIME MARK OUT+
GPS 429 OUT A
GPS 429 OUT B
VOR/ILS 429 OUT A
VOR/ILS 429 OUT B
NOTES:
1. ALL WIRES TO BE 24 AWG OR GREATER UNLESS OTHERWISE NOTED.
2. AT IFD540 UNIT, TERMINATE SHIELD GROUNDS TO THE CONNECTOR BACKSHELL OR
USE CARD-EDGE CONNECTOR TO TERMINATE SHIELD GROUNDS TO BACK PLATE –
THE SHIELD LEADS MUST BE LESS THAN 3.0 INCHES. CONNECT OTHER SHIELD GROUNDS TO
AIRCRAFT CHASSIS WITH AS SHORT A CONDUCTOR AS PRACTICAL.
REFER TO THE MANUFACTURER'S DOCUMENTATION FOR COMPLETE PIN-OUT AND
3.
INTERCONNECT INFORMATION. PIN-OUTS OF OTHER UNITS SHOWN FOR REFERENCE ONLY.
4. FOR PROPER SETUP TO INTERFACE WITH THE G600. REFER TO THE G600 INSTALLATION
MANUAL. APPENDIX E (P/N 190-00601-06).
6. FOR OTHER CONNECTION OPTIONS REFER TO THE G600 INSTALLATION MANUAL.
600-00299-000
P1001
48
49
56
16
46
47
P1006
24
23
Figure D - 34: Garmin G600 Interconnect
Page 173 of 198
IFD5XX Installation Manual
GDU 620 PFD/MFD
P6202
3 ARINC 429 OUT 1A
20 ARINC 429 OUT 1B
12 RS-232 IN 3
46 RS-232 GND 3
40 TIME MARK IN 1A
N/C 41 TIME MARK IN 1B
6 ARINC 429 IN 3A
23 ARINC 429 IN 3B
7 ARINC 429 IN 4A
24 ARINC 429 IN 4B
Revision: 02