Avidyne IFD540 Installation Manual page 157

IFD540 #1
3
SERIAL DME DATA
SERIAL DME CLOCK
SER DME-CHAN REQ/PAR DME-4MHZ
DME COMMON
SER DME-RNAV MODE/PAR DME-2MHZ
IFD540 #2
3
SERIAL DME DATA
SERIAL DME CLOCK
SER DME-CHAN REQ/PAR DME-4MHZ
DME COMMON
SER DME-RNAV MODE/PAR DME-2MHZ
NOTES:
1. ALL WIRES TO BE 24 AWG OR GREATER UNLESS OTHERWISE NOTED.
2. AT IFD540 UNIT, TERMINATE SHIELD GROUNDS TO THE CONNECTOR BACKSHELL OR USE CARD-EDGE CONNECTOR TO TERMINATE
SHIELD GROUNDS TO BACK PLATE – THE SHIELD LEADS MUST BE LESS THAN 3.0 INCHES. CONNECT OTHER SHIELD GROUNDS TO
AIRCRAFT CHASSIS WITH AS SHORT A CONDUCTOR AS PRACTICAL.
3. 3 THE IFD540 MUST BE CONFIGURED AT INSTALLATION TO OUTPUT KING SERIAL DME TUNING DATA UNDER THE DME CHANNEL MODE.
REFER TO MANUFACTURER'S DOCUMENTATION FOR COMPLETE PINOUT AND INTERCONNECT INFORMATION. PINOUTS OF OTHER
4.
UNITS SHOWN FOR REFERENCE ONLY.
600-00299-000
IFD5XX Installation Manual
P1006
19
18
20
22
21 N/C
P1006
19
18
20
22
21 N/C
Figure D - 21: King Serial DME Tuning Interconnect, Remote Mount
Page 157 of 198
Bendix/ King
KDI 572 KDI 574
P5721 P5741
11 11 DATA BUS
12 12 CLOCK BUS
17 17 RNAV REQUEST
N/C 33 33 10 BIT/50 BIT SELECT
48 48 NAV 1 COMMON
49 49 NAV 2 COMMON
15 15 DME REQUEST
Bendix/King
KN 63 KDM 706
P631 P7061
6 9 DATA BUS
F 8 CLOCK BUS
D 24 DME REQUEST
Revision: 02
DME
DME